Immunohistochemical labelling of spinal cord sections for chemoarchitectural analysis of segments

John-Paul Fuller-Jackson, Peregrine B Osborne, Janet R Keast

Published: 2024-07-24 DOI: 10.17504/protocols.io.14egn6376l5d/v1

Disclaimer

ETHICS DISCLAIMER

The protocols.io team notes that research involving animals and humans must be conducted according to internationally-accepted standards and should always have prior approval from an Institutional Ethics Committee or Board.

Abstract

This protocol is used for immunohistochemical visualisation of the chemoarchitecture of the adult rat lumbosacral spinal cord (and other segments for comparison). Spinal cords were sub-dissected into segments, and transverse sections were obtained from across the rostrocaudal axis of each segment. Two combinations of antibodies were used:

  • Combination 1: neuronal nitric oxide synthase (nNOS), choline acetyltransferase (ChAT) and NeuN
  • Combination 2: calcitonin gene-related peptide (CGRP), vesicular glutamate transporter 1 (VGlut1) and tyrosine hydroxylase (TH)

Steps

Sub-dissection of spinal cord into segments

1.

In a silicone gel-lined petri dish, immerse the fixed spinal cord in phosphate-buffered saline (PBS; 0.1 M, pH7.2).

2.

If still present on the spinal cord, carefully remove the dura mater from the outside of the spinal cord using fine forceps and iris scissors. Take care not to damage the spinal cord or remove the spinal roots as these will be needed as landmarks.

3.

Pin the spinal cord flat by laying the spinal cord dorsal surface facing the gel, and individually pinning all of the ventral spinal roots out perpendicularly.

4.

Identify each of the spinal cord segments using the following landmarks:

  • Each segment is defined by a ventral root, with the boundaries between segments where one set of rootlets ends, and another begins.
  • In the lumbar spinal cord, the lumbar enlargement is the widest portion, containing segments L3-L5.
  • The ventral roots of the sacral segments are much thinner than those of the lumbar segments.
5.

Starting with the most caudal segments, use a scalpel blade to sub-dissect each segment, cutting at the exact point between two sets of rootlets. Store the segments in separate tubes of PBS containing 0.1% sodium azide, labelled appropriately until further use.

Preparation of cryosections

6.

Cryoprotect fixed spinal cord segments in PBS containing 30% sucrose. This should be performed at 4 ºC, 24-72h prior to cutting.

7.

Embed tissue in cryomold using OCT, freeze in cryostat and cut sections (40 µm), collecting sections progressively across sets of 4 wells to collect 160 µm spaced series.

Immunostaining

8.

Wash sections in PBS (3 x 10 min)

9.

Incubate sections in blocking solution at room temperature for 2 h

10.

Incubate sections in appropriate dilutions of primary antibodies (or combinations of primary antibodies) for 48-72h. Antibodies are diluted in PBS containing 0.1% sodium azide, 2% horse serum, and 0.5% triton-X.

11.

Wash sections in PBS (3 x 10 min)

12.

Incubate sections in appropriate dilutions of secondary antibodies (or combinations of secondary antibodies) 4 h in the dark. Antibodies are diluted in PBS containing 2% horse serum, and 0.5% triton-X.

13.

Wash sections in PBS (3 x 10 min)

14.

Mount sections onto glass slides and coverslip in preferred anti-fade mountant.

Microscope

15.

Labeled neurons are counted and classified according to their immunoreactivity, including only nucleated neuronal profiles in the analysis.

Note
For digital analysis, tile-scanning of complete spinal cord sections is recommended, ensuring that the order of sections (rostral to caudal) is noted.

推荐阅读

Nature Protocols
Protocols IO
Current Protocols
扫码咨询